CPQMEM.EXE
                         INSTALLATION INSTRUCTIONS
 
    This program allows the COMPAQ SYSTEMPRO base memory to be set at 512K 
    (permitting the Banyan ICA card memory to map from 512K to 640K).
 
 
SYSTEM REQUIREMENTS:
 
    COMPAQ SYSTEMPRO
    COMPAQ MS-DOS Version 3.0 or greater.
 
 
WHO SHOULD USE:
 
    Use this program if you wish to set your SYSTEMPRO base memory to 512K 
    and to switch it back to 640K.
 
 
HOW TO USE:
 
    1.   From the A prompt, type CPQMEM.EXE then press <ENTER> to run the 
         program from your distribution diskette.
 
    2.   Once the opening menu is displayed, continue to press <ENTER> to 
         open the sublevel menus.
 
    3.   The last sublevel menu will allow you to choose between 512K and 
         640K for base memory by pressing <ENTER>.
         NOTE:  You can only change the content of the highlighted block.  
         All other information can not be modified.
 
    4.   The number in the highlighted block represents the base memory 
         that your system is set in (or will be set in).  Press F10 to 
         save your choice and press <ESC> until you return to the A 
         prompt.
 
    5.   Reboot your system to make the change effective.
 
 
    Comments:
 
         There are no command line parameters.
 
 
EFFECTS ON YOUR SYSTEM:
 
    The base memory of your system is now set to your choice (as 
    determined in step 3 above).  If it is set at 512K, you need to use 
    the program CF12.EXE to run the COMPAQ System Configuration, CF.EXE.  
    Please contact your COMPAQ authorized dealer to obtain the program, 
    CF512.EXE