WINIPX.COM
                         INSTALLATION INSTRUCTIONS
 
 
INTRODUCTION:
 
   WINIPX.COM is a program for use with any 386 COMPAQ Computer products 
   experiencing problems when running the following combination of 
   software:
 
        Novell Workstation IPX shell
        Novell Netbios Emulator
        Any Netbios applications (e.g., DCA Irmalan Gateway)
        IBM Lan Support Program
        Microsoft Windows 3.0 (Enhanced mode) on AT LEAST one workstation
 
 
SYSTEM REQUIREMENTS:
 
    Any COMPAQ 386 systems and IBM Token Ring adapter.
 
 
WHO SHOULD USE:
 
   You should use this driver if you encounter system lock-up or 
   timing-out problems when running a Netbios application with the above 
   hardware and software configurations.  Please note the presence of 
   Windows 3.0.  This driver should not be applied if you are not using 
   Windows 3.0 Enhanced mode on at least one workstation.
 
   If you use Windows 3.0 Enhanced mode on all the workstations, the 
   problem might not occur.
 
   Important note: WINIPX.COM should be applied only to the workstations 
   NOT running Windows 3.0.
 
 
HOW TO USE:
 
   1.Copy the driver file WINIPX.COM into the same subdirectory where the 
   Token Ring IPX driver is located.
 
   2.The order of loading software is as follows:
 
             ...
             IPX.COM
             WINIPX.COM (needs to be loaded IMMEDIATELY AFTER IPX.COM)
             ...
             NETBIOS.EXE
             INT2F.COM (recommended by Novell)

   3.The following logo will be displayed as WINIPX.COM is loaded:
 
             WINIPX version 1.0
             Copyright Compaq Computer Corporation 1990
 
   WINIPX.COM will not allow multiple installations.  The following error 
   message will be displayed if it detects that it has already been 
   installed:
 
         WINIPX version 1.0
         Copyright Compaq Computer Corporation 1990
         *** Already installed ***
 
 
EFFECTS ON YOUR SYSTEM:
 
   WINIPX.COM will consume about 300 Kbytes of system memory.  You can 
   unload WINIPX.COM once it is loaded by typing:
        WINIPX /u
   or   WINIPX /U
 
   The following message is printed if WINIPX.COM can unload itself:
 
        WINIPX version 1.0
        Copyright Compaq Computer Corporation 1990
        *** WINIPX successfully unloaded ***
 
   If any TSR is loaded after WINIPX (e.g., NETBIOS.EXE), WINIPX will not 
   unload itself, since these latter TSRs might be hooked into WINIPX.  
   The following error message is displayed as a warning:
 
        WINIPX version 1.0
        Copyright Compaq Computer Corporation 1990
        *** TSR loaded after WINIPX ***
        *** Please unload them before unloading WINIPX ***