INSTALLATION INSTRUCTIONS
INTRODUCTION:
LTPENDRV.SYS is a driver to be used with CBTP.COM or PCMIS.COM
files on most COMPAQ computers with VGA that has problem using
TDS light pen software from TDS Healthcare Systems Corporation.
SYSTEM REQUIREMENTS:
Deskpro 286e
Deskpro 286N
Deskpro 386/20
Deskpro 386N
Deskpro 386s
Deskpro 386s/20
Deskpro 386/25
Deskpro 386/20e
Deskpro 386/25e
Deskpro 386/33
Deskpro 386/33L
Deskpro 486/25
Deskpro 486/33L
Systempro 386
Systempro 486
COMPAQ MS-DOS Version 2 or greater.
WHO SHOULD USE:
Use this program if you are having problems using TDS light pen
software on the above COMPAQ computers.
HOW TO USE:
1. Copy the program LTPENDRV.SYS from the distribution
diskette to your system diskette or fixed disk.
2. Using an editor, add a line to your CONFIG.SYS file to
execute the command at system boot.
3. The syntax of the program is:
DEVICE=[d:][path]LTPENDRV.SYS
Comments: There are no command line parameters.
4. When the package is successfully installed, you will get
the following message:
LTPENDRV.SYS is Installed.
(C) Copyright COMPAQ Computer Corp. 1991
If the package is not successfully installed, an error
message will be generated.
5. Copy the program CBTP.COM to the subdirectory where the
program CBTP.EXE will be run from.
6. Copy the program PCMIS.COM to the subdirectory where the
program PCMIS.EXE will be run from.
EFFECTS ON YOUR SYSTEM:
1. Since the file LTPENDRV.SYS is a device driver it will use
approximately 1000 bytes of system memory.
2. Once installed, the program cannot be unistalled until the
system is rebooted.